Performax 16-32 Plus Drum Sander Rebuild

DrCori · Apr 17, 2022

I just received a 2003 Performax 16-32 Plus Drum Sander. Price was right (free). It has sat unused for the last 18 yrs. The motors run, drum spins and the belt works. Those are the good points.
Because it has sat for so long the threads to raise and lower the motor are full of grime. I used some WD40 and a rage on it and it moves but is still very hard to turn the handle.
I figure my best course is to tear the whole thing down and clean, lube and align everything.
My question is what kind of lube should I use on the threads and misc. bolts.

Thanks Gary

Vandon · Apr 17, 2022

Light sewing machine oil

splintergroup · Apr 18, 2022

Could be issues with the guides (sliders) on the motor faceplate mount. Do not attempt to adjust these unless it's a last resort, but try some light oil on the tracks where they slide.

DrCori · Apr 18, 2022

I believe you're right it is the guides sticking. I'll take the drum and housing off so I can get to the guides and try cleaning them with some acetone then oil.

splintergroup · Apr 18, 2022

My point about adjusting them is they are very touchy to restore the correct tension. I was trying to lessen some slop on my 16/32 and found they go from too tight to sloppy loose with a slight fraction of a turn. Too tight and your raise/lower threads with begin to self destruct.

Great score on a useful machine for a rock bottom price however!

Performax 16-32 Plus Drum Sander Rebuild

Top Contributors this Month

Recommended Communities