Welcome To LumberJocks.com
Woodworking
Skill Share
Tools & Jigs
Workshop
Woodworking Business Discussions
Marketplace
LumberJocks Classifieds
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
Forum Support
Off Topic Discussions
Regional Discussions
Meetups, Clubs, Guilds, Connecting With Others In Your Area
Blogs
Reviews
Latest Posts
-
Off Topic Coffee LoungeJust what the title says. At one time, one was sent to the Woodshed to fetch a switch. Because they broke some sort of rule… Because they "misbehaved" Because they didn't fit in with a certain group….. So…this will be all about that sort of thing….been blocked? Had a thread you were on...
- 11K
- 177K
-
Power Tools, Hardware and AccessoriesHello just found this forum today hoping someone can help me out. I have a delta unisaw 34-802 single phase 3 hp motor. I need a new start stop switch. Is there an aftermarket switch I can replace the original with? Also if it’s not the switch what is a common issue that would cause it not to run
- 21
- 482
-
FinishingI am using General Finishes Arm R Seal oil based topcoat in Satin (no gloss) to finish a project (TV stand) I made out of white pine. Before any topcoat was applied, the wood was sanded with 220 grit sandpaper. I put my first coat of Arm R Seal on and then after it dried, I noticed the wood felt...
- 0
- 22
-
I will be doing a glue up shortly for a TV stand that is 89" long. I've never done a glue up for a project this size and I am a bit intimidated. I plan to glue up and use pin nails to hold pieces in place and then clamp. I worry about glue setting and a piece ends up crooked or out of square. I...
- 10
- 781
-
General Woodworking DiscussionsI haven't glued up this joint yet. It is just clamped to show the problem. Some careless sanding left a chunk missing out of the top of the vertical section as shown in the photos. Can this be fixed with wood filler or sawdust / wood glue mixture? If it can be fixed, should I fix it before glue...
- 32
- 2K