LumberJocks Woodworking Forum banner

Could pine be used for counter tops?

Tags
pine question
32K views 11 replies 10 participants last post by  Tbay  
#1 · (Edited by Moderator)
I have collected full size 2×4 x 8 feet long pine wood from a trucker and was wondering if i could turn it into my new countertop. Its the only wood thats in my budget at the moment. Is there a disadvantage on using pine for a countertop?
 
#3 ·
Pine is considered a soft wood, so you do need to be mindful of that, however if you do as Monte says and use one of the resin-based products out there, I have no doubt it would look great. I used oak for my two bathroom remodels and then used a marine-based Spar and people love the wood look in the house. I didn't have to use a heavier epoxy because it was oak, but pine would have worked fine as long as it had a hard coating placed on top.
 
#5 ·
+1 on the epoxy. Pine will darken nicely over the years but because its soft and youll be using it, you need to seal it. Im also pretty sure pine has some resins in it you dont want to have near your food. Im in the middle of an epoxy job with West epoxy systems. I got it at Lee Valley and couldn't be happier.
 
#7 ·
If you have the tools, time and patience, you could cut that board into short end grain pieces and glue up to form an end grain top. That would partially negate the softness factor and the grains would add beauty. For wood counter tops, I always finish with 2 part varnish (Minwax works).
 
#9 · (Edited by Moderator)
Say, ask around and find a friend who has a jointer, a surface planer, and a tablesaw. You'll want to get all of those 2×4s smooth square and straight for the glue-up. If any of the boards have crooks or non-straightness to them cut them shorter before jointing to remove the crook and you'll be able to lay them up once all the pieces are straight. For your purpose, gluing two smooth 2 or 4" wide surfaces together will be plenty strong without any interlocking glue joints.

I second Charles' comment about making the top surface end grain, but another option would be to cut and arrange the boards so that the top surface is quartersawn, meaning the growth rings are running vertical from the top to the bottom of the countertop. In essence, you're looking at the edge grain as your top rather than what would normally be the face grain. I think this looks better for pine and will make it look less like 2×4s. Google "quartersawn pine images" to see what I mean about the growth rings running perpendicular to the face of the board.

Edit: following up on dhazelton's comment below, the quartersawn suggestion would also help limit expansion across the width of the countertop to about 1/2 that of a flatsawn layup.
 
#12 ·
I thank you all for the comments and Im going to try my best using all your wisdom in my first project.

Thanks Charles, i will use your end grain top idea.

Thanks BobAnderton for your milling tips

Thanks dhazelton for your fastning down the countertop tip.

My first counter top cabinet project might take some time to complete. I hope i can finish it within 2 years. LOL