LumberJocks

Rockwell 37-220 table adjustment

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by mysigha posted 10-20-2020 09:43 AM 204 views 0 times favorited 2 replies Add to Favorites Watch
View mysigha's profile

mysigha

1 post in 43 days


10-20-2020 09:43 AM

Topic tags/keywords: rockwell 37-220 jointer table adjustment

I have a Rockwell 37-220 that I have pretty well dialed in. WHAT I NEED HELP WITH IS…the infeed table is perfectly square to the fence. But the outfeed table is very slightly off (not 90 degrees to the fence) and gets worse as I measure away from the cutterhead. The worse point (at the end of the table) is about 1/64’ or less.


2 replies so far

View JonJD's profile

JonJD

7 posts in 192 days


#1 posted 11-10-2020 05:19 PM

You may try shimming the ways or adjusting the gibs.

A good rundown can be found in Grizzly owner’s manuals. Check out pg 46 of this manual Checking/Adjusting Table Parallelism />https://cdn0.grizzly.com/manuals/g0855_m.pdf

View Richard Lee's profile

Richard Lee

325 posts in 1695 days


#2 posted 11-10-2020 06:30 PM

Could be the fence not the table.
I have the same Jointer and had to fix my fence.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com