LumberJocks

Customer Display Stands

  • Advertise with us

« back to Sweating for Bucks Through Woodworking forum

Forum topic by Madmark2 posted 02-27-2020 12:31 AM 657 views 0 times favorited 2 replies Add to Favorites Watch
View Madmark2's profile

Madmark2

3261 posts in 1928 days


02-27-2020 12:31 AM

Topic tags/keywords: pipe pine dowel bevel wax paste johnsons sanding drill press router sander tablesaw finishing modern

My customer sells a variety of pipes and smoking accessories and needs various display stands for the oddly shaped bits and bobs.

It’s a ‘whatzis’ stand

This is the second stand I made for them. The first was similar but had three rows of 1/2” posts whereas this version has two rows of 3/4” posts. I dropped off the first one yesterday and my customer was so pleased they immediately ordered the 2nd one.

The beveled edge detail is common to both stands as is the 10-1/2” width. The bevel was cut 3/8” x 45° with the 1/2” 3-1/2 hp Milwaukee table router.

They both have the makers mark and felt feet on the bottom. No scratching the customers counters.

I had a rubber stamp made – LOTS cheaper than a branding iron and no warm up!

They are finished with two generous coats of Johnson’s Paste Floor Wax and lightly hand buffed.

They each took and hour or so to make and cost about $5 in clear pine and dowels.

-- The hump with the stump and the pump!


2 replies so far

View Kelly's profile

Kelly

3899 posts in 4284 days


#1 posted 02-27-2020 03:04 AM

Short, sweet and simple. It’s easy to lose sight of that, sometimes. Good job.

View SMP's profile

SMP

5082 posts in 1245 days


#2 posted 02-27-2020 03:11 AM

Its like a reverse router bit stand lol

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com