DELTA 12" RAS dust collection

Very interested as I have the same saw. I wanted to build something below the table, but I’m not sure how. I know I’d like a 4 inch pipe with a reducer so I can keep a shop vac there permanently. I hope we hear from someone with experience. I know there is A LOT of stuff on You Tube. Check out You Tube videos by Tommy Thompkins and from Frank Howarth. Both use DeWalt saws, but I think the information is still very valid.

-- When you earnestly believe you can compensate for a lack of skill by doubling your efforts, there is no end to what you CAN'T do

jack take a look at what i did on my 10” craftsman ras,this might work for you,it’s worked very well so far on mine.

-- working with my hands is a joy,it gives me a sense of fulfillment,somthing so many seek and so few find.-SAM MALOOF.

I also have a Craftsman 10”. My dust catcher is kinda sorta similar to what pottz did but, not nearly as refined. I just built a box behind the blade with a forward facing opening about 6-8” wide and tall right behind the rear edge of the table. The DC hose then attaches to the side of the box. I then plugged up the port on the blade guard. This does a pretty decent job of catching the dust. Certainly not 100% but, most of it.