LumberJocks

Help with router bit choice?

  • Advertise with us

« back to Woodworking Skill Share forum

Forum topic by Woodrabbit posted 12-03-2018 02:46 PM 353 views 0 times favorited 6 replies Add to Favorites Watch
View Woodrabbit's profile

Woodrabbit

1 post in 231 days


12-03-2018 02:46 PM

Topic tags/keywords: router bed router profiles woodworking router bits question tip jig

Please look at the last image of this bed- the bottom rail. They have done something….like a chamfer bit on the top two sided with stops blocks for keeping the ends square to make the shadow line. I am trying to recreate it. Any ideas?

Thanks!!

https://www.etsy.com/listing/632265997/modern-maple-walnut-platform-bed-with?ref=related-2


6 replies so far

View 000's profile

000

2859 posts in 1320 days


#1 posted 12-03-2018 03:26 PM

Is this what you are asking?

View Jeff's profile

Jeff

507 posts in 3615 days


#2 posted 12-03-2018 03:34 PM

It’s exactly what you describe, a chamfer bit stopped before going through the edge. Probably routed before cutting the tenons so there’s some wood to support the router. Relatively easy to do either free hand or on a router table.

View GR8HUNTER's profile

GR8HUNTER

6225 posts in 1133 days


#3 posted 12-03-2018 03:35 PM

J has the correct answer to your ? :<))

-- Tony---- Reinholds,Pa.------ REMEMBER TO ALWAYS HAVE FUN

View SMP's profile

SMP

1190 posts in 326 days


#4 posted 12-03-2018 04:47 PM



It s exactly what you describe, a chamfer bit stopped before going through the edge. Probably routed before cutting the tenons so there s some wood to support the router. Relatively easy to do either free hand or on a router table.

- Jeff

Yep I do that on my router table, I just stick masking tape on the fence to mark where to start and end the cut. Test with a scrap piece.

View oldnovice's profile

oldnovice

7487 posts in 3788 days


#5 posted 12-03-2018 06:54 PM

You can also do a simliar treatment with a cove bit.

I use start/stop blocks on the fence to locate the length of the cove/chamfer.

-- "I never met a board I didn't like!"

View a1Jim's profile

a1Jim

117655 posts in 3998 days


#6 posted 12-03-2018 07:07 PM

Hello Welcome to Ljs
If you have a table saw why not do a bevel on it? I missed the part about leaving the ends square,

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics

HomeRefurbers.com