mappa burl voids

  • Advertise with us

« back to Finishing forum

Forum topic by shieldsie posted 10-22-2018 11:15 PM 532 views 0 times favorited 2 replies Add to Favorites Watch
View shieldsie's profile


9 posts in 657 days

10-22-2018 11:15 PM

Hello everyone!

I am working on a mappa burl piece that will eventually be a ‘river’ style table. I have flattened the piece and cut it in half. Before i pour all the epoxy for the river i was thinking of filling all the small voids with clear epoxy; and this is where i was looking for some insights.

My thought here is to use the same ‘Ecopoxy Liquid Plastic’ to fill the voids. I will put tuck tape on the bottom side fill the voids group by group and then come back and top them off. I figure with the liquid plastic it has a long pot time allowing me more time to be meticulous. (which i most often am)

Sound like a good plan? I have seen the ebony epoxy to fill the voids as well and it looks quite nice! So i was hoping to get some opinions based on what others have done with mappa burls and what you may find worked / looked best.

thanks everyone!

2 replies so far

View Andybb's profile


2784 posts in 1410 days

#1 posted 11-12-2018 07:59 PM

Clear or add some dye to the epoxy to match the wood. Depends on your personal taste and the effect you want.

Welcome to lj.

-- Andy - Seattle USA

View shieldsie's profile


9 posts in 657 days

#2 posted 11-12-2018 09:12 PM

I did end up using just clear. Basically just did 3 or 4 seal coats and then did the flood coat I’ll post some pictures shortly. It turned out quite nice. And! Being a novice I learnt alllllot! Lol

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics