installing a incra ls-17 to a unisaw

  • Advertise with us

« back to Jigs & Fixtures forum

Forum topic by ruger posted 07-08-2018 03:36 AM 652 views 0 times favorited 3 replies Add to Favorites Watch
View ruger's profile


136 posts in 707 days

07-08-2018 03:36 AM

hello, I have a bench dog cast router wing mounted on the left side of my unisaw. today I ordered the incra ls 17 fence kit . to use as a router fence. I make a lot of keep sake boxs and urns. all of my dove tail work has been with a porter cable dove tail jig. want to do different joinery other than the standard joints. my question is those who own this fence system how have you mounted it to a unisaw to use a left side mounted router wing? I went to the incra pdf instructions and they have you mount it to a laminated type router table.. can I mount it to my miter t tracks on my table top or am I going to have to mount it on a wood base and align and clamp it to my table top? I guess the best set up would have been order the table saw fence system with rails and all the correct hardware but thats not in my budget and i like my unifence. thanks,

3 replies so far

View ruger's profile


136 posts in 707 days

#1 posted 07-08-2018 01:02 PM

what I plan on doing is making a sled and attaching it to my miter slots with the ability to snug it down. thanks

View splintergroup's profile


3222 posts in 1834 days

#2 posted 07-08-2018 02:11 PM

My first thought was to do as you intended, mount the Incra mechanism to a board attached to a good fitting miter bar. If you have “T” miter slots, clamping down will be a cinch!

View ruger's profile


136 posts in 707 days

#3 posted 07-09-2018 08:47 PM

after a little research incra miter sliders are my best bet. on a incra build it panel.. panel is pre drilled for their slider tracks and you can lock them down to take any slop out of tracks. or i can make my own. but going with the incra due to the ability to lock the tracks.

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics