incra hold down

  • Advertise with us

« back to Woodworking Skill Share forum

Forum topic by wuzfuzde posted 04-16-2011 02:26 PM 2576 views 0 times favorited 2 replies Add to Favorites Watch
View wuzfuzde's profile


27 posts in 3130 days

04-16-2011 02:26 PM

perhaps this is a good time to ask a table saw question and -yes i have 2 RAS and a tablesaw non of which are less welcome in my shop.
anyway on my table saw i have a incra 2000 miter . most of the incra’s life has been spend sitting watching me so recently i decided to begin using it to cut segmented pieces of maybe a inch .
Much to my delight it cut well and consistent which is important in angle cutting—-but and there is always a but… in cutting these small pieces my original issue of 10 fingers was entirely too close to the whirling finger eating blade.
I would really like to find a hold down device that works with my incra… So the short version anyone know of such a hold down ..i really prefer not to go back to my home made sled.

2 replies so far

View Cosmicsniper's profile


2202 posts in 3638 days

#1 posted 04-16-2011 05:07 PM


You could modify this idea to something useful for you…

It’s more for smaller miter cuts, but you could certainly figure out a clamp solution to hold the piece on.

Otherwise, I’ve tried to avoid going to the very end of a board when using the miter sled on small pieces.

-- jay,

View Peteybadboy's profile


1013 posts in 2429 days

#2 posted 10-15-2018 09:20 PM

I’m working on the same problem. !

I’m going to try this. Need a long “screw” with rubber finger for a toggle clamp. Not sure you can see this image.

I called Incra and they sent me a few ideas

-- Petey

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics