Help with Craftsman 22124 Tablesaw assembly.

  • Advertise with us

« back to Power Tools, Hardware and Accessories forum

Forum topic by plang posted 02-11-2018 02:28 AM 714 views 0 times favorited 2 replies Add to Favorites Watch
View plang's profile


137 posts in 4272 days

02-11-2018 02:28 AM

Finally. after 12 years, there it is, unboxed and completely naked is my brand new 12 year old 22124. OK enough of that. My issue is that my cast iron extensions drop about a sixteenth of an inch. I have tried using a wedge but then there is a gap at the joint. Any help would be appreciated. Thanks.

2 replies so far

View Kelster58's profile


759 posts in 1457 days

#1 posted 02-11-2018 02:55 AM

I was able to use painters tape on the bottom edge of the table to shim the extension. I found clamping a piece of woo onto the center part of the able top then loosely clamping the wing to the boards helps hold them in place while bolting up the wing. Check this out about 4-1/2 minutes in…...

-- K. Stone “Tell me and I forget, teach me and I may remember, involve me and I learn.” ― Benjamin Franklin

View BirdseyeBill's profile


8 posts in 270 days

#2 posted 04-27-2020 08:07 PM

Will the Freud SD 608 8’’ dial-a-width Dado Set fit on the Craftsman Zip Code Saw 22124?

Birdseye Bill

Have your say...

You must be signed in to reply.

DISCLAIMER: Any posts on LJ are posted by individuals acting in their own right and do not necessarily reflect the views of LJ. LJ will not be held liable for the actions of any user.

Latest Projects | Latest Blog Entries | Latest Forum Topics