[dannelson]

Check out the one that portercable makes the benchtop unit dont remember how much I paid but it has cut 10's of thousands of pockets and I only replaced 1 router. and very very fast. the only drawback it is set up for 3/4 stock

 

[dannelson]

thought I saw a pc knock off by general or woodtec recall it being green and yellow hope this may help. I would think that you can build on pretty easy off the pc design it uses one router for the swing(to cut the pocket from underneth and a trim router withe a drill bit to bore the hole into the piece.

 

[dannelson]

yes that the one Castle> I have seen the pneumatic ones used and have considered bidding but so many other tools to buy . you might want to check out EX FACTORY its a used machinery site also WOODWEB dont yet know how to get those to highlight in blue and be a link. Ill work on that