LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 5 of 5 Posts

·
Registered
Joined
·
12 Posts
Hello all,

I am finally getting around to building a workbench top burly enough to support the Tucker and Twin-screw vises that I picked up used a year ago. I have located detailed instructions on how to properly install the Twin-screw vise but I can't seem to find any information about how to do the same with the Tucker vise. A quick search of the LJ forums did not produce any results specific to Tucker vise installation or instructions, but perhaps my search abilities are too limited?

Does anyone out there have a copy of the Tucker vise installation instructions that they would be willing to scan and send my way? I understand from what I've read thus far that one must be quite precise when installing such vises, and I would very much like to read the manual rather than attempt this process intuitively.

Many thanks for any help that you can provide, and apologies if this is a topic that has already been covered that I have simply failed to locate.

Will
 

·
Registered
Joined
·
12 Posts
Discussion Starter · #3 ·
I have looked at the Lee Valley website and could find no information about installing a Tucker vise as they no longer manufacture the vise. But it didn't occur to me to contact them directly to see if they could furnish me with a set of plans-thanks for the recommendation! I'll see what their Customer Service folks have to say.

Cheers,

Will
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top