LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 1 of 1 Posts

·
Registered
Joined
·
235 Posts
Discussion Starter · #1 ·
Thin kerf blade problem solved.

Thin kerf blade and splitter.
I sanded down the splitter on my bench sander with 80 grit.
First measured blade width then proceeded to sand until splitter thickness was less than the blade.
Now one splitter is a universal one. Took about 15 minutes, tied back pawls, sanded all the way up.
No kick back, no pinching, no burn marks. Freund TKB
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top