LumberJocks Woodworking Forum banner
1 - 3 of 21 Posts

· Registered
Joined
·
2,392 Posts
MT... YES, that is a woodworking RULE…

BUT, you might apply the tips in the short video and maybe you can get them in synch! :)

- Joe Lyddon
Joe, That guy was using the same tape measure as mine. :) It's a 12 footer so not bulky.

Mostly, I use a Lufkin folding ruler I have had for many years. Made in the USA! :)
 

· Registered
Joined
·
2,392 Posts
I carry a free HF tape measure in my truck and our Chevy Traverse. Their sole purpose is to have on hand when shopping for lumber or whatever. No need for exact measurements.

However, when the rough cutting is over and done with, the Lufkin folding ruler takes over from there. I use it to set the table saw for ripping or cross cutting., measuring for shelves, drawer bottoms, etc.
Just sayin'
Font Rectangle Tints and shades Automotive exterior Automotive lighting

Light Automotive tire Font Gas Audio equipment


Rectangle Office ruler Water Font Material property


Crankset Motor vehicle Automotive tire Font Gas


Ruler Office ruler Camera accessory Measuring instrument Scale
 

Attachments

1 - 3 of 21 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top