LumberJocks Woodworking Forum banner
1 - 1 of 21 Posts

· Registered
6,267 Posts
I use a block of hardwood with a dado cut through as shown in the sketch to check the tape reading. Place the tape in the groove and ensure the 2" mark lines up with the block. Bend the hook with pliers if not. The block allows you to check your tape frequently.

Rectangle Handwriting Parallel Font Slope

Dimensions are not critical except for the 2.000" dimension. The closer, the better.


1 - 1 of 21 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.