LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 3 of 3 Posts

·
Registered
Joined
·
213 Posts
I try to get my blade 0.000" to 0.001" but would settle for 0.002" without much complaint. I tail my fence out between 0.002" and 0.005" at the rear. I don't know for a fact that 0.010" will cause problems but I would think about bringing that one down a little myself.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top