LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 2 of 2 Posts

·
Banned
Joined
·
403 Posts
I made my first router table insert for my table saw. I Routed out the space for the router plate and got a little sloppy. Too much space.

My dad use to GLASS LINE Rifle stocks and I think thats would be perfect to make my router table insert fit tight as a drum.

Any other suggestions
 

·
Registered
Joined
·
364 Posts
If all the "slop" is lateral i.e. side-to-side, then bedding or glass lining similar to bedding a rifle action would work very nicely. Just be sure to apply a release agent such as Pam spray or vaseline etc to your insert so that the epoxy will not stick to the plate.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top