One other idea is to put a Carnuba paste wax finish over your Danish oil finish. It is fast and non toxic. I have used that with good success and it leaves a nice wood feel. It can also be touched up occasionally if necessary. I usually rub it on with a white 3M pad to work it in. Then buff it to a soft shine. If you don't have the white 3M pad one of the other less abrasive pads will do. The white 3M pad has no abrasive embedded in it.
Shellac over Watco Danish Oil
The topic of walnut and danish oil and such has been touched on a bunch in these forums, so I apologize ahead of time for any repetition. However, I was unable to find an answer to my specific questions, so here they are:
1) Will one coat of Danish Oil on Walnut sanded to 220-girt penetrate the surface to the point that superficial scratches will not be obvious (this is for a child's chair)?
2) Will a shellac finish over the Danish Oil cause any problems, such as bleeding from the alcohol solvent in the shellac, and will pushing the 72-hour minimum by a couple of hours (say 5 or 6) run this risk of ruining the finish (I turned my shop into a wind tunnel to try and speed the process/ humidity in the area should be around 40-50% for the next couple days)?
I'm a bit under the gun, as the chair is for my first nephew who I will be flying to see on Friday morning. I applied the Danish Oil Monday night, and would like to do a couple coats of shellac Thurs. afternoon/evening. I will be packaging the chair to be checked luggage (any thoughts on this as well?) on Friday. Any and all comments are appreciated.
![]()
1) Will one coat of Danish Oil on Walnut sanded to 220-girt penetrate the surface to the point that superficial scratches will not be obvious (this is for a child's chair)?
2) Will a shellac finish over the Danish Oil cause any problems, such as bleeding from the alcohol solvent in the shellac, and will pushing the 72-hour minimum by a couple of hours (say 5 or 6) run this risk of ruining the finish (I turned my shop into a wind tunnel to try and speed the process/ humidity in the area should be around 40-50% for the next couple days)?
I'm a bit under the gun, as the chair is for my first nephew who I will be flying to see on Friday morning. I applied the Danish Oil Monday night, and would like to do a couple coats of shellac Thurs. afternoon/evening. I will be packaging the chair to be checked luggage (any thoughts on this as well?) on Friday. Any and all comments are appreciated.
1 - 1 of 7 Posts
1 - 1 of 7 Posts
