LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 8 of 8 Posts

·
Registered
Joined
·
308 Posts

·
Registered
Joined
·
3,238 Posts
Any turning I have done I have needed to glue up blanks which entailed getting wood flat and straight in order to glue it up. Spindle turning you sometimes need to take the square edges off before turning the block round. You might want to rethink selling everything until you've done a little turning.
 

·
Registered
Joined
·
308 Posts
Discussion Starter · #5 ·
Thanks to everyone that mentioned I may need some machines for wood turning. I am keeping the bandsaw. Most of what I've read is that enough for most cases. Buckethead is partially right. Not married, but to buy a lathe need to sell some existing machines and tools.
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top