LumberJocks Woodworking Forum banner

Repurposing repurposed wood beams

678 Views 7 Replies 5 Participants Last post by  Unknowncraftsman
I'm renovating a cabin that was built in 1950. Everything was repurposed to build then. I saved the roof rafters in hopes to use them somewhere and I think I landed on door trim. I took them out in July and they sat outside until today when I brushed the snow off then and brought them inside. I'm still debating on if I want to take a hand planer to them to take off the old finish and splinters. If I do I'd have to stain and seal, if not I'd like to just use a hard sealant.

Few questions:
1. Should I be treating these somehow/way?
2. They were dry for maybe a hundred years, they have been in the elements for 6 months now. Roughly 2.5"x5". How long to dry?
3. Can anyone name the species of wood? I did plane one down a little.

Thank you

Wood Rectangle Natural material Hardwood Plank

Wood Road surface Automotive tire Rectangle Composite material

Door Fixture Building Wood Floor

Wood Road surface Flooring Brick Brickwork

Wood Natural material Composite material Building material Hardwood
See less See more
1 - 3 of 8 Posts
I'd like to preserve the rough cut antique look if I can, but I also don't need anymore slivers from these things... If I plane them I'll use my cheap WEN electric hand planer as there are tons of nails and staples.
How much were/are these things worth? I had 8 at about 14' before I decided to cut them down for door trim... I have a few smaller dimensions ones that look the same I plan to use for decor of some sort.
1 - 3 of 8 Posts