LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 2 of 2 Posts

·
Registered
Joined
·
1,147 Posts
I don't know that saw but it might have another stud to position it. Take the wing nut off and try pulling off to the side from below.

Besides, there are many times that you would want to take off the splitter that even the most safety conscious would agree to. Kind of hard to make a dado with the splitter there ;)
 

·
Registered
Joined
·
1,147 Posts
Looking at Fig 5 on page 5, it might be a lot easier with the blade off. I bet that you will have to loosen up the wing nut (maybe even take it all the way off) to get it to clear some stud that keeps it from spinning around the bolt that the wing nut is on.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top