LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 1 of 1 Posts

·
Registered
Joined
·
207 Posts
I had the Rout-R-Lift in my PM2000 for a long time before I went to a new table. The Rout-R-Lift is a good piece (made by JessEm) and worked fine. I never felt lacking for the miter slot but I have a full router table in the shop also. Whenever I needed guidance for the router I would use the the PM2000 fence or a clamp-on fence and never had an issue with that.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top