LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 1 of 1 Posts

·
Registered
Joined
·
217 Posts
Would anyone happen to know how to change the table gear on a PM2800B ?

I got one for Xmas, table doesn't fit over the rack or work properly when setup on a bench so PM sent me a new worm and gear for the table assembly but I have no idea how to remove the drive shaft the gear is mounted on.

Is that likely to be a press fit or have a retaining screw somewhere ?

PM Customer Service is only open 9-5 M-F, which is not very convenient for a weekend warrior

Thanks in advance
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top