LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
When I loaded my first tails bit I was very surprised at how shallow the shank depth in the collet could be to hit the pre-determined depth measurement for the jig. Maybe half the shank is supported by the collet. Maybe less. Doesn't seem safe. Anybody else seen this? BTW I have a Bosch router.
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top