LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 3 of 3 Posts

·
Registered
Joined
·
123 Posts
I have some 1/4" wide by 8"diameter grindng stones that I would like to use to make some spoon bits. I have the 01 drill rod and I was planning to grind out the spoon part. The grinding stones have a 1 1/4" diameter hole in them and I need a mounting flange so they can go on a 1/2" diameter drive shaft. Any ideas where I could find such parts so I can safely use them?

Thanks,
Jim
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top