LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 2 of 2 Posts

·
Registered
Joined
·
6,953 Posts
I made a lathe duplicator using 1/4" x 1/4" piece of HSS tool bit stock. It seemed to work well once I got the angle correct on the cutter.
 

·
Registered
Joined
·
6,953 Posts
The cutter "angle" that worked best for my application (french rolling pin arc) was grinding a rounded end. If plunged straight in, it would make a cove cut. However, it also gave me the cleanest cut when moving it along the horizontal axis of the rolling pin. I tried a cutter ground for removing metal along the horizontal axis and it gave a rough/ragged cut.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top