LumberJocks Woodworking Forum banner

Making 3" tapered legs

1205 Views 2 Replies 2 Participants Last post by  BriMtl
Any suggestions on making the 3"(at the top) legs for this table?
Wood will be walnut.
I'm more concerned with the grain orientation and the glue line.
Was thinking of simply gluing two thick pieces together, matching the grain of the 2 halves best as I can, and then tapering them.
Thanks in advance.
See less See more
1 - 3 of 3 Posts
As far as grain orientation goes check this out: http://lumberjocks.com/topics/2229
Thanks for the reply. I'm aware of the grain orientation.
However my concern here is the thickness of the pieces being 3" and having to glue up at least 2 pieces.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top