LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 8 of 8 Posts

·
Registered
Joined
·
9,241 Posts
Interesting.

Belated welcome to Lumber Jocks.

Let's say you shim one leg 3/8" to level it. Scribe every leg 3/8"
and you should be good to go.

I like to use a simple scribe:




When you move your item to another location and the new location has a different slope then
it'll be out of level again. Oops.
 

·
Registered
Joined
·
7 Posts
Discussion Starter · #8 ·
Yeah, it definitely felt that way. Part of the reason I couldn't quite figure it out. How do I get the relatively flat top equidistant and level with the relatively straight leg ends. Maybe I'm thinking about it too much.

Dagwood Bumstead dealt with this problem a few days ago. Check it out. He ended up with a very short table.

- runswithscissors
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top