LumberJocks Woodworking Forum banner

I need advise about I minimally need to sharpen my chisels and plane irons

3K views 22 replies 12 participants last post by  CharlesA 
I use a mixture of things

Grinder for the new bevels ( some that show up here have a ~ look to the edge)
MK1 Honing guide running on a beltsander, IF needed after the grinder
A Double sided oil stone with 3in1 oil, and the MK1
A 12×12 floor tile, and a few strips of wet or dry sand paper. Goes up to 2500 grit. The MK1 stay put through all the above. Remeber to treat the back of the cutter, too.

Have an old belt, wornout as a nail pouch belt. Cut a strip of it, and load it with the Green Polishing stuff. A few hard pulls to strop, and call it done
Wood Ingredient Hardwood Table Flooring


At one time, that little block plane had trouble making splinters…
 

Attachments

This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top