LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 1 of 1 Posts

·
Registered
Joined
·
964 Posts
A while back Peachtree Woodworking had the MagJig on sale. I purchased two and the corresponding 40mm forstner bit.

Last week I was making a jig and thought I would try out the MagJig. After drilling the home with the 40mm bit I found that it took a vice to press the MagJig into the hole and I needed a piece of scrap wood and a mallet to remove it.

Is the hole supposed to that tight of a fit?
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top