LumberJocks Woodworking Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
1,332 Posts
CMS cross cut sled fast mount, easy to use.

Festool CMS cross cut sled
fast mount, easy to use.

Here a little idea I got the other day, to make my latest cross cut sled for the Festool CMS table more easy to use. Normally it was screwed in place, with two wing nuts, to secure the sled to the fence, but it meant that I found it time consuming to take it on and off, what lead to often not using it…

So I came up with this little mount, that simply clicks in place and where I don't need to fine adjust the fence to fit to the screws.

I have not made a blog on the cross cut sled, as this is quite basic and you will be able to find plenty of build plans for that, but I will go through it.


Here the sled, mounted on the CMS table, before I made the new mount.
A quite basic sled, that helps me prevent tear out, due to the fact, that the CMS has no zero clearance plate insert.
I have tried to keep it as light weight as possible, to make it easy to take on and off, but in my next version, I will keep the right side straight, so I can get a full runner there on the underside.


The construction is quite simple, a base plate, two fences and a runner, that runs in the groove between the CMS and the long arm for the CMS sled, but it would be even more accurate, if it got a runner on the right side also, following the edge of the table, on this one, it just have a small one at the end of the pointed corner.
The runner is made from IKEA cutting board.


Always happy when I get to the shop and find a letter from my daughter.
She writes.
Hey, passed buy with a school friend on a walk, he is a huge fan. Kisses Mathilde.


Back to the sled, here on the table, with simple C-clamp fence stop and held with wing nuts.
The red half circles are just for safety, to remind me where the blade goes and keep my fingers on each side.


This is the thing we will be making, a mount that simply fits into the T-track on top of the CMS fence.


Let's make the fast mount.
A piece of wood, here plywood gets a rabbet, that correspond to the one on the fence.


Like so.


Hardwood cut to size, made to fit into the rabbet and deep enough, to get well into the T-track.


Make sure you get a tight fit.


Do you get the picture?


We have a mount.


The hardwood is a wee lover, so when it's mounted in the rabbet, it will not touch the bottom of the T-track.


Cut to length.


Using the sled - smiles.


Now the mount can be attached to the fence.


Just screws.


Here we have it in place.


Underside.


Finally in place.


Ready to cut some wood and to be taken on and off in a second, I can already see, that I use it more, due to the fact, that it's not a screw on unit now.
(I must be lazy…).

Hope it can be to some inspiration, or a sled, now winter is up…
(MaFe, you got such a terrible sense of humour).

Best thoughts,

MaFe
I am getting no pics. Any Ideas?

Madts.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top