LumberJocks Woodworking Forum banner

Drilling straight holes in crooked wood (rustic log and stick furniture)

11030 Views 5 Replies 6 Participants Last post by  dennis
Hey gang.
Ultra new guy here. I searched for quite a while for the answers to my questions and didn't find them so I hope I am not repeating past questions.

I have been building log (aromatic red cedar) furniture for a while now. Mostly large, unfinished, half log benches and straight(ish) 4-5" log/stick furniture. I am pretty good at carving tenons with a heavy machete and a draw knife since I really don't care for the look of tenons made with cutters. So far most everything I have ever made sold within days so I figure I ain't to horrible at it.

I have had a great old, backwoods, fur faced, hillbilly teachin me how to do this an so far it's worked out very well. Now I would like to graduate into makin more stuff out of crooked logs and branches but he just shakes his head an thinks I am crazy for wanting to. The thing I find hardest to do is getting the holes drilled correctly. Compound curves in each piece I am trying to join just makes it extremely difficult thus far.

It there is one thing I loath, its ruining a piece with a hole drilled at an incorrect angle. Especially after I went through the hassle of pickin it out, harvesting it, luggin it home, (often on my back), peeling it and so on. Of course the stuff I do ruin can always be used on somethin else or for firewood but that doesn't really make me feel better when stuff doesn't fit together.

Does anyone have any advice on drilling and assembling one curly-q branch/log into others? I have see many pictures on the net of chairs, swings, bed frames and such where every single piece of material is crooked and twisted an different form all the others with angles goin off in every direction. Not the air nailed, willow, stuff but the Mortise an tenon stuff. I have had a little success with it but I am still ruining stuff as well. Any advice or links to videos showing how to do this more accurately and consistently?

Please refrain from shakin yer head an tellin me I am crazy for wanting to make this stuff, or I'll photoshop your last project into a crooked, warped poorly finished, catastrophe and re post it! > :)

See less See more
1 - 6 of 6 Posts
I don't think any one here is going to say you're crazy. Especially if they know anything about what you're doing. Depending on where you try to sell that kind of stuff, you can make a fortune. I don't have an answer for you and just in case none of the LJ's know, check out
I know someone on this site will be more than happy to share their knowledge.
How about posting a pick of what you are trying to do. A visual would be great.
Here is the tenon cutter setup I use and a link to the internet company (Bosworth Tools) I used. All total it was about $1000 (including the cutters).
1. Use a drill press
2. Use a jig to guide your drill

Get this DVD from Lee Valley:

Lee Valley
Good luck…thats why we call it art. Call me if you figure it out.
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.