LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 1 of 1 Posts

·
Registered
Joined
·
12 Posts
Still in gear acquisition mode but had a thought come to mind since I've got a relatively small space.

Is there any reason why nobody's mounted a router under a drill press? You could have a single table/fence system for two tools that spin bits in the same direction. If it's been done, has anyone done this on a table saw wing? Because if so, I could definitely justify splurging on an incra fence that could be used for 3 tools….
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top