LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.
1 - 2 of 2 Posts

·
Registered
Joined
·
541 Posts
I'm working on a slab of maple and have applied two coats of Minwax Tung Oil Finish. There are a few spots of small tearout I see now that I'd like to go back and resand. Is that possible? or am I just going to muck things up. I'd assume in the best case scenario I'd resand and then reapply tung oil in those spots. I'm planning on finishing with a few coats of poly after the Tung oil.
 

·
Registered
Joined
·
541 Posts
Discussion Starter · #4 ·
Ugh. :) We're talking 3'x6' and I already don't like sanding…

Part of me wonders if I can get enough layers of finish going to fill the defects. Tung oil, however, soaks in more than it sits on the surface, correct?
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top