LumberJocks Woodworking Forum banner
1 - 1 of 1 Posts

· Registered
Joined
·
105 Posts
I always switch between my 1/2'' and my 1/4'' blade. At the beginning of a project I use my half 1/2'' blade for all of my mill work and re-sawing. And the when I finish all of that I look into the project and see if I have any hefty work that my 1/4'' can't do, If not I go ahead and change the blade and a do all my curve cuts.
It is a pain but it works and I'm doing Ok with it.
Matthew
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top