LumberJocks Woodworking Forum banner
1 - 1 of 24 Posts

· Registered
336 Posts
I run standard kerf (1/8 in) blades on my vintage 3 hp Rockwell Unisaw. Never been able to slow it down pushing 8/4 and thicker hardwoods. The only reason to use a thin kerf blade on your saw would be save lumber if ripping lots of thin strips from some valuable wood.
1 - 1 of 24 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.