Search Results for ‘troubleshoot’

Hello all - I've worked to finish my first box project - when installing the butt hinges all looked good until I did final tighten down - now the box wants to be very slightly open (1/16 inch or so) rather than sit flush/closed. I'm sure that this is something I'm doing obviously wrong/off - but...

I have had a Jet 1236 for about ten years now and the speed adjustment knob has been getting harder and harder to move. It has a Reeves drive and looking at it, I cannot see anything that looks out of place. The only video I could find online just showed WD-40 being sprayed on the springs and...

Hi, this is my first post and I'm hoping to find some answers. I recently bought a delta 34-410 contractors saw that appeared to be in decent shape. I should also add this is my first cast iron saw, up until now I've had portable saws so the parts and mechanics are new to me. I Tested it and it...

I have a Rockwell Delta 17-600 drill press with a vfd. It was running smoothly and then it started to get a little loud. Now when I try to turn it on, it whirs but doesn't move and I get an "oca" error on the vfd. I looked that up, indicating an over current error and perhaps the torque...

I am building my first vanity for our master bath. Being that this is a temporary home for us but wanting to build my skill, I decided to try full extension drawer slides for the first time. I am going with a cheap option off amazon the corresponding rear mount brackets. My issue is more in my...

Hi, I inherited a table saw and I'm trying to get it running in my garage. I have it all hooked up the way I thought would work, and it won't start. I was hoping I could get some troubleshooting advice here. First, the saw: Manufacturer: Busy Bee Model: B210A Volts: 115 Phase: 1 Cycles...

initial thoughts Decided to make a workbench for my father for a belated Christmas and birthday gift. (Working on it in the evenings after my brain is fried from writing). The space he has available is small, so I am going to scale it down to be roughly 20" x 60" or a bit longer. Based off of a...

I have the Ridgid jointer (JP6101). When I run a pieces of wood through my planer, the inside (towards the fence) gets cut more than the outside edge. If I run it through enough, I end up with a bit of a trapezoid (looking at a cross section of the wood) 1) I have set and double checked my...

I have been successfully embedding videos into my blogs for a while now but all of a sudden they don't show up. I have been simply copying and pasting the embed code from YouTube into my blog body paragraph. I even compared the code I'm using now with the code in my most recent blog entry and...

Hi fellow jocks! Yesterday I purchased a brand new skil bench top drill press. (You know the one from the home center…) Today when I unpacked and assembled it I noticed that the quill meets some resistance along its travel. When you release the lever the spindle stays down and I have to manually...

Hi guys. I've run into a problem with my table saw that I need some help troubleshooting. I've had the saw (a Craftsman 2-HP hybrid) for a little more than 2.5 years and haven't ever had this problem before. I had used the saw quite a bit yesterday and, frankly, a ton over the last 6 weeks with...