LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-9 of 9 Results
  1. kitchen island

    Here's my new kitchen island. Made from red oak if anyone couldn't tell. It is made of 4 separate cabinets and the base is one separate piece as well. I ran power into the base and on one side where I had room. I even made the countertop myself-first time for that. That was the easiest part but...
  2. Toothpick Holder

    Finally I got one of these done. This is Spalted Walnut with a Maple finial and cup.
  3. Business Card Holder

    I made this quick business card holder for my wife so the cards aren't just floating around in her purse. Roughly based on card holders by ghazard and junji, this one is made of walnut and curly maple with a toothpick as the hinge-pin. The "lid" stays shut simply by friction. Finished with...
  4. Need A Toothpick?

    Some inventory for upcoming craft shows … these are a great way to use up scraps! These are based on a project by Dennis Belcher, which appeared in the August 2019 edition of the American Woodturner, the journal of the American Association of Woodturners.
  5. Bowling League Entry

    Toothpick and Stand Cherry 'pic and stand. Copper stand arms. Finished down to 400 grit paper, then down to 2000 grit emery cloth. 7 coats of tung oil over 7 days, with 0000 steel wool between coats. Wipe on poly for protection, then a coat of paste wax. Yes, I am kidding. Lopsided Bowl...
  6. Miniature Birdhouse

    This is my submission for the birdhouse contest. I decided to do something different and miniaturize it. I had been thinking about trying to build a miniature bandsaw box around the same size, and also wanted to build a birdhouse for the contest. The bandsaw box fell by the wayside, but I...
  7. Off Topic Coffee Lounge
    Check out this guy building 1/64th models with toothpicks:
  8. Off Topic Coffee Lounge
    Could you accomplished carvers tell us what are the best carving woods besides basswood and catalpa?
  9. Safety in the Woodworking Shop
    Hi fellow LJ's, just a quick question, I have almost completed my cyclone DC, it's made of 99% wood, however inside there is a short piece of 4" PVC, about 14-16". Here is the question, since there is only one small part of the DC that is using PVC pipe inside the cyclone, do I need to run a...
1-9 of 9 Results