Search Results for ‘screwdrivermarking tool swap’

As the title of the post suggests, the latest swap was screwdrivers and marking tools. Since I don't have a lathe to make handles for the obvious entries, I decided to make a trifold bit index that I came across in the Woodsmith plans. It holds both drill bits and the various driver bits. It...

This is my project write up for the 2022 Screwdriver/Marking Tool Swap. The project is basically in three parts: the screwdrivers, the marking tools, and the storage box. All Claro Walnut with brass details. The screwdrivers shafts are a bit of a story. My grandfather started a company doing...

For the Screwdriver / Marking Swap I choise to go the route of Marking and layout. First up was a Marking Knife (blade from Taylor Tools) I made the scales from Purpleheart , and attached them with Brass Pins. Then I Made an Awl, using Ash and Purpleheart, the blank was turned and finished on...

Box is made from curly maple and walnut. Screwdriver is made from grandiollo handle and a multi screwdriver from harbor freight with th handle removed. The hinges on the box were installed with barbed hinges with a slit cut.

This was a fun Swap project. I figured most would go with screwdrivers. I went with primarily the Markers theme. Multi-use Screwdrivers These were made from a Performax 6-in-1 Multi-Screwdriver. I removed the plastic handle, then cut the shaft in half. Then made maple wood handles. Awl &...

ok here are my swap items that went to my recipient earl.ill try to remember what i did,cant be worse than losing the letter describing the details from my sender keebler. #1 is the four items i made an awl,6 in 1 screwdriver, a large combo shop pencil/pen and a key chain with screwdriver bits...

This is a set of turnscrews I made, based off London Pattern Turnscrews from an old Marples catalog. Then I tweaked them to match turnscrews sold by Swan early in the 20th Century. They are sized to fit wood screws of even sizes from 2-8. I cut the blades from O-1 tool steel, filed the tips to...

For the screwdrive/marking tool swap I made several screwdrivers. The first is padauk and maple glued together. I did some multiaxis turning for this off 4 points. I epoxied the ratcheting screwdriver kit from woodcraft in the end. Finished with woodturners finish. The next screwdriver is one...

Here's my entry for the 2022 screwdriver/marking tool swap. It had been a long time since I took part in a swap and I was glad to finally get back into it. This set went to Bill Berklich and I hope is is well pleased with it. I had a set of the Grace tools shanks from a past swap and decided to...

How do you make a screwdriver without a lathe, hmmm. seems there are a LOT of ways to work wood down to something close to a round shape. I tried many of them, and came up with the following. I started with several small billets of curly Maple, and Walnut. I never actually measured them, but I...

First I have to give Devin T credit for the first two pictures great work!!. And yes for this 2022 Screwdriver Marking Tool Swap my package went to Devin T a multi-talented maker. As this was a Screwdriver swap first, the initial piece was screwdriver with a ratcheting drive. It was a bit tight...