Search Results for ‘router carving’

The cabinet was in a very bad shape. I had to replace two doors, two shelfs, all the lower side panels. The engraving had to copy to the new doors. Finished with different stains, shellac and rubbed in wax with orange oil. The hardware's were painted and finished with lacquer.

Wooden sign made of walnut (I came to possesion of some boards of ''young'' walnut tree - it didn't turned brown yet). Dimension 80×30cm. I transfered printed pattern with indigo to wood, than carved all with 3 and 4 mm router bit 1 mm deep. I painted letters groves with black water based...

One small quick project - salt box 14×12x11cm, made of ash, finish wood oil. Hinge is 2.5mm brass pin. Additionaly, I made smal spoon, also of ash, with Arbotech angle grinder router, later sanded with oscillating spindle sander.

Here are a couple of bed side stands that I through together for our bedroom and the guest bedroom. I added sides and a full door in front for our room and left them open for the guest room. Guests can easily see if they have left anything behind by having it open. I used the same basic design...