LumberJocks Woodworking Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-4 of 4 Results
  1. Router Table

    I made this router table from Russian birch ply for the carcass, 1 1/2" MDF with white laminate on top and a special skin on bottom (yes, MDF can warp). I used a Woodpecker Quicklift with a PC 7518. I wired it so it has a switch on the front, plug inside the router compartment, and a 2 gang...
  2. Power Tools, Hardware and Accessories
    Howdy. I have an opportunity to buy a PC 75182 that was made in the US and is new old stock. Comes with the fixed base, too, and 1/2" collet. It was a floor model I guess and never used. I talked him down to $215 but not sure if it's worth it since I just need the motor to hand in my lift...
  3. Power Tools, Hardware and Accessories
    Just built a new router table and having some issues. 1. The Porter Cable motor, which is the default motor for the Mast-Lift-II, won't fit in the carriage. I've loosened the tensioning cap screw all the way, and the motor still won't fit. I even loosened all of the clamping blocks to give...
  4. Blogs
    Router Table Cabinet This is a router table I'm working on for my shop. I was able to incorporate most the features I needed and plan to use it often. It isn't finished but most the major parts are in place. I purchased the Incra twin linear, router table top...
1-4 of 4 Results
Top