LumberJocks Woodworking Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-7 of 7 Results
  1. Master-at-Arms Coin Display

    A gentleman approached me at a craft show and asked if I could do a custom coin display for a friend. He brought me the coins and I inset them into a piece of walnut flooring I got from an elderly woodworker who was closing his shop. I've never done a custom coin shape other than round so I did...
  2. Candle Holder from dunnage

    The wife and I go to the thrift stores looking for things I can incorporate into my woodworking. We picked up the glass cylinder for a couple of bucks. I used a pre-made bowl blank to make the base. In use the candle sits on a glass plate. Base is about 8 inches in diameter. Base and cylinder...
  3. Candle Holder, colored plywood

    We picked up a wire-framed candle holder a couple months ago. It held 3 floating candle holders. Then we got a couple of pieces of color laminated plywood. So I thought I'd make a holder. Sanded to 320 grit. 2# shellac buffed off while wet. Buffed on the Beall System.
  4. Hanging Challenge Coin Display, from Dunnage

    I made these a while back and just realized the only picture I'd posted was when I tried cutting my finger off a Trepanning (circle cutting) bit. Made from scraps of dunnage left from squaring stock on the tablesaw. Each hole is cut to fit the coin. But in requiem, the wood is so thin, (about...
  5. Cyndi's Bookcase - Quarter sawn red oak.

    Dec 2014 Here's a bookcase, similar to the one I posted earlier "Liam's Bookcase", made from quarter sawn red oak. My client wanted red oak, not my favorite, and when Woodcraft had a killer wood sale with QS red oak at less than $4/bf I couldn't resist. During my Sickley phase, a bedroom...
  6. Blogs
    Beall System, Versatile. I got a Beall system a few years ago. I started with the 3 circular pads. I liked it so much I also got the 3 polishing balls to do inside bowls. I also got an old motor for $2.00 at a garage sale so I could have a dedicated polishing setup. The motor is plugged in to...
  7. Power Tools, Hardware and Accessories
    I got a DW733 planer at an estate sale a few year ago. I've run a few hundred linear feet of hardwood through it since I got it. Last year the feed rollers started skipping, bad for planing boards. Did some research that indicated a worn chain, so I replace the roller to roller chain. That...
1-7 of 7 Results
Top