Search Results for ‘pedestal’

Hello, I thought I'd share my first marble machine project with this forum. I've wanted to build a marble machine for a few years now, and first decided to search the web for plans. I was a little disappointed with what I found: not much. For the most part, the designs I found online didn't...

My next project is a pedestal table. The pedestal is square but tapers up. Any ideas? I was thinking about cutting the taper then the miter on each side???

I've seen more than one Floridian lamenting the cost and scarcity of Walnut here in Florida. While perusing my local Craigslist, I found 'a guy' who seems to have a fairly ample supply, at a reasonable rate. After calling him, it seems he is down to 300-400 BF of mostly 4/4 rough sawn stock...

Its a Godfather weekend, what is your favorite line.

Are they saying that this can be wired to run on 220 or 440 3 phase? "great for the garage, 208 - 220/440 3 phase" Bidding is at $200

I posted this on craigslist but thought I would give it a try here also. I upgraded awhile back to a 15" Delta but hung on to this "in case" I needed it on a job site. Instead I just planed anything I needed in the shop on the Delta and took it to the site. So long story short, the Dewalt is up...

Cast your vote for the next Lumberjocks tool swap (external link for casting vote). You have the option of writing in an item if you do not see what you would like. Whatever gets the most votes (or write ins) will become the next swap. Once the next tool swap project has been established, you...

Hi I am building a 72" round table out of 1" black walnut. There will be a 4" apron. I was thinking of using a 10" pedestal base with legs that are around 14" in length. My question is, is this enough support? Should the legs be longer? Two pedestals? Any advice on support for the pedestal...

Good Evening everyone, I have just started the process of designing by far my largest project to date. The boys at the station have mentioned building an "heirloom" dining table to replace the cheap standard issue melamine ones we have. I jumped at the opportunity to design something and...