LumberJocks Woodworking Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-6 of 6 Results
  1. Folding; Sliding; Table Saw Extension Wing

    This Extension Wing was made out of a piece of oak butcher block. The Wing has three runners also made out of the same butcher block. Two of the runner guides attached to the existing out-feed table and the third slides in the fence guide. The wing is about 9" wide. It doesn't extend the full...
  2. Flip-Up (Fold-Down) Table Saw Out-Feed Table

    I picked up a new table saw the other day (Ridgid R4512) and knew the first thing I wanted to add was this out-feed table. I am restricted on space (two car garage but my wife's only request is that she's able to park in it at night) and therefore make all of my stands/benches mobile and...
  3. Out-feed Table for my Sawstop

    This is the out-feed table that I built for my Sawstop. I used plywood, black laminate, and 1×4s. Entire project cost between $40 and $50. Gave me more work space than the $100 table from Sawstop. If you don't have an out-feed table, it is a major convenience in the shop!
  4. Blogs
    TS3650 and RS1000 Snagged A Ridgid TS3650 table saw and a Ridgid RS1000 radial arm saw last night. A BIG thanks to BOTIETRUCK for telling me about the listing on Craigs List. It was an hour and a half drive down to Kill Devil Hill to look at it, but we hopped in the Excursion to look at the...
  5. Off Topic Coffee Lounge
    Hey - do you enjoy perfect joinery? Check this article out, especially the slideshow… -Mr. Measure Twice
  6. Wood & Lumber
    I'm trying to mill some old wood to have the rough kerf marks on some of the surfaces but I can't seem to find a way to make my 'clean cut' saw kerf look distressed after cutting. I'm not sure if it requires a special blade, modification of an old blade or some other technique but I know for...
1-6 of 6 Results