LumberJocks Woodworking Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. Box

    !http://s293.photobucket.com/albums/mm54/azal2008/thGlasswoodenboxessnow200854-1.jpg(boxhttp://s2}!!(box)!!93.photobucket.com/albums/mm54/azal_2008/th_Glasswoodenboxessnow2008054-1.jpg(Box)!!http://s293.photobucket.com/albums/mm54/azal_2008/th_Glasswoodenboxessnow2008054-1.jpg(Box)!
  2. Mesquite Extension Dining Table

    Mesquite Extension Dining Table-Here is the table I will post more detail pictures when my photographer gets done with them.The base is six bentwood legs tied together in the middle with a round piece inside.The top is 56" diameter and expands to accept a 20" leaf.All is inlayed with...
  3. Mesquite table

    Mesquite table-Now That I have gotten good pictures I want to show everyone.This table is Mesquite with a Walnut/Maple bentwood curved line sandwiched in between two halves of the table.The joinery close up is under the table were the legs come together. The pedistal base is all carved and hand...
  4. Mesquite Dining Table 75 x 40 for sale (unfortunately)

    Here is my newest table. It is about 75" long by about 40" wide. Made out of solid mesquite. The top is a solid 2 inches thick. I am finishing the chairs and will post those pics soon. The finish is a Target Coatings Water Based Conversion Varnish. This was going into my dining room but I...
  5. Power Tools, Hardware and Accessories
    My 5" Bosch random orbital sander (ROS20VS) came with a "soft" hook and loop backing pad. I kind of shredded it quickly, too much pressure I guess, and need to replace it. Toolbarn.com carries hard, soft, and extra soft replacement pads. I haven't been able to find any guidance on when to use...
  6. Power Tools, Hardware and Accessories
    I am anxious to get this figured out since the only way this is going to fit into my garage is to get enough mobile velocity so that it can make it's own space! I just bought an old Powermatic table saw and need a mobile base for it. It is a pretty old one with an open bottom on the cabinet...
  7. Power Tools, Hardware and Accessories
    So I now have an Incra TS-LS system for my [email protected] Ryobi contractor table saw. I need some input as to how much room to allow for ripping. Because of the old style contractor non-riving knife set-up, I will have to cut the rear fence to allow for the blade guard and splitter to still work. The...
1-8 of 8 Results
Top