LumberJocks Woodworking Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results

    Custom Live Edge Tables On Hair Pins.
  2. My Workbench

    I completed this workbench using reclaimed barn timber from a barn that had stood for over 90 years in southern Maryland farm. The barn was taken down and the timber had been left out for mother nature to care for it when I got to them, a lumber jock dream…. The wood timbers took a couple of...
  3. Cutting Board with a Twist

    Another cutting board using evil pine…...then took a torch to the sides! Was kinda reluctant to burn sides but after sanding surface of burned area then adding mineral oil I kinda like it :)
  4. Power Tools, Hardware and Accessories
    Hello, I am new to posting on this page, but after reading for a while I thought this group would be of some. I recently acquired a Delta 36-431 contractor saw with Beisemeyer fence used on Craigslist. I went through all of the procedures to align the blade, and even talked to a senior tech at...
  5. Blogs
    Today I purchased two georgous walnut slabs and sanded to a smooth surface Today I was at a friends shop learning how to do a polished finish as part of an apprenticeship program of The Sierra Nevada Fine Furniture Makers Guild and ended up purchasing and sanding down these two amazing...
  6. Wood & Lumber
    Greetings forum members! We just finished up on another stunning live edge walnut contemporary dining table that I wanted to share with the group. I own and run, Refined Elements, which is based outside of Austin, TX. We have the one of the largest live edge walnut inventories in Texas...
  7. Wood & Lumber
    I have approximately 2100 board feet of american chestnut that started out as a 26 foot log as well as a seven foot chunk as well. the log was bucked at about 13 feet and was four feet and change at the butt, with little taper. they have been cut into 3 1/2 inch live edge slabs,and kiln dried...
1-8 of 8 Results