LumberJocks Woodworking Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. On-Off Switch at chest level for a dust collector

    Here's a little workshop helper I've found very handy. This on-off assembly is mounted to my two stage Jet dust collector. Jet placed the original on/off switch on the motor assembly which is about 18" off ground level and behind the blower unit. Bending over, somethimes around other...
  2. Panel Carrier & Dolly

    Panel Carrier & Dolly I have to admit that I'm not getting any younger so I need some helpers carrying sheet goods. Out of some old scrap cut offs of whatever I found in front of me I quickly made a Panel Carrier to bring the sheets from the car inside the shop and a Panel Dolly with a clamp at...
  3. shopsmith connecting tube project tray

    Hi, This is a project for a shopsmith 505/510/520 and uses the connecting, either the 27" ones or the 5 footers. It clips to the tubes using "grip clips" (an item that has been around since before I was a kid for holding mops and brooms and what have you.) This set of grip clips is for 3/4"...
  4. 4X4 Hub Unlock Tool

    My wife doesn't have the finger strength to lock and unlock the hubs on her 4X4, so I made this little doo-dad for her last night. Seeing that I was out of the country for the house move I couldn't supervise or even pack my old workshop, and I haven't been able to find most of my stuff. With...
1-5 of 5 Results
Top