LumberJocks Woodworking Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. Crib

    This is a Crib that I built for my daughter. It is a convertible crib that converts to a toddler bed and then into a headboard for a full size bed. The lumber is Ambrosia Cherry, which is actually Ambrosia Maple that has been processed to give a pinkish color. It has a coat of Minwax Red...
  2. Chevron patterned Cutting Board

    Hi guys Just finished this 2 inch thick edge grained chevron patterened Cutting Board… [rough measurements…16 in by 16 in] Made from Purple Heart, Silver Ash, Tasmanian Blackwoodn New Guinea Rosewood and a sliding dovetail keyed spline in the mitred border made from Camphor Laurel… finished with...
  3. Safety in the Woodworking Shop
    I would like to spray some waterborne finish on some projects, and my only 3 options in terms of location would be: 1. garage (somewhat dusty and hot/cold as it's not insulated) 2. outdoor (windy, sand, grass, rain possibilities) 3. basement (very stable climate, clean, washer/dryer/stuff...
  4. Safety in the Woodworking Shop
    I saw a notice displayed at the Tacoma permit counter yesterday. I thought it might be of interest to many of the LJs, especially those attempting DIY shop wiring. Hazard: The books contain errors in the technical diagrams and wiring instructions that could lead consumers to incorrectly...
1-5 of 5 Results
Top