LumberJocks Woodworking Forum banner
  • Please post in our Community Feedback thread for help with the new forum software! If you are having trouble logging in, please Contact Us for assistance.

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-8 of 8 Results
  1. Lion cut out

    Fun piece to cut. This lion is cut from poplar with a scroll saw and framed in a painted pine.
  2. Navy plaque

    I cut this plaque using a scroll saw using birch ply. Gold brads on frame outside to add flare. Asked to make for a friend.
  3. OV-22 Osprey Gear Display Case

    Being retired Navy and living in a large military area I get some pretty unusual requests. This project was a going away gift from the Officers at a local OV-22 squadron to their Commanding Officer. The gear inside is from one of the transmissions in the aircraft. (The part in the display is a...
  4. The Bus to Cornith

    This is a very different project for me. Made this replica for my DNL as a gift for her author who wrote the book titled as post title says. The author rode a bus just like this to Cornith, Greece to research the book. Enough history. This was copied from a live picture. There is a lot of tools...
  5. Wood U.S. Map for State Quarters

    This is a project that I made for my Mom who collects state quarters. I purchased the plans from Rockler, and I used all scraps from the guitars I've made. I cut out the states with a scroll saw and jewelers saw. Then finished with Tru Oil. Woods used were Rosewood, Cocobolo, Engelmann Spruce...
  6. Power Tools, Hardware and Accessories
    I have a split tank air compressor setup with a silent air oil bath compressor filling a small 1gal portable unit. From this unit I have a little regulator and inline separator ($12 mastercraft, nothing special). I also have an unregulated output I run to a 20gal wheeled tank.The big tank I...
  7. Focus on the Workspace
    Hey everyone! I just bought a new house that has a completely unfinished basement. The walls are 9ft of concrete and I'm deliberating how I should go about the workshop portion of the basement. In order to please the wife I've agreed to wall of the section of the basement that will contain...
  8. Jigs & Fixtures
    I have been thinking about getting into pocket hole joinery and I am wondering what Kreg jig to get. There seems to be so many. My main focus will be to make face frames for cabinets. I can't decide between the K4 and the R3. There are quite a few others that I would consider, I am just...
1-8 of 8 Results
Top